- Description
- Technical Details
Our Peak Performance Upgrade will make sure you're getting the most out of your radio. Be heard loud, and crystal clear.
When you're buying a new radio you wanna make sure it's ready to roll. Our Peak Performance package will get the President Lincoln II in tip top shape with software / firmware updated. We include the new President Digimike that adds a Noise Cancellation Circuit for remarkably clear transmissions.
LINCOLN-DIGI Features
- VFO Mode(continuous scanning of 24.890 Mhz to 24.990 Mhz and 28.000 Mhz to 29.700 Mhz)
- Manual squelch and ASCASC (Automatic Squelch Control automatically suppresses unwanted noise)
- Multi-color DisplayAmber, Green, and Blue
- FiltersANL filter, NB and HI-CUT. Helps filter out unwanted noise
- Channel and Memory ScanScans frequencies for activity
- 6 Memory Channels Allows you to store up to 6 different channels for easy access
- Repeater TonesCTCSS (38 tones), DCS (104 codes)
- DimmerControl the brightness of the backlight
- ModesAM/FM/LSB/USB/CW and PA
- Dual watchAllows you to monitor 2 frequencies
- SWR Protection and Voltage ProtectionHelps protect the radio when there are SWR problems with an antenna system or high voltage
- Additional Features
- TOT (Time Out Timer) adjustable
- External Speaker Jack
- Roger Beep
LINCOLN-DIGI Technical Specifications
Important notes on power output
|
---|
Measuring power output will vary depending on many variables. Our default test-setup consists of a 14-volt power supply, 50 ohm dummy load, and Bird wattmeter reading PeP (peak envelope power). If you are using different equipment, measuring RMS instead of PeP, or have an SWR reading different than shown, you may have different results. The following chart shows an example of power readings for this radio with changes to measurement variables. Final note, the Dosy meter referenced below is directly affected by the SWR readings in the antenna system. You may notice huge differences in power readings from subtle changes in SWR.
|
---|
|
---|
Bird Wattmeter
|
---|
Voltage | 14VDC
|
---|
SWR | 1.2 with dummy load
|
---|
Impedance | 50 ohm
|
---|
AM Carrier (low w/ 50W slug) | 2W
|
---|
AM Carrier (high w/ 50W slug) | 12W
|
---|
AM Modulation (PeP w/ 100W slug) | 50W
|
---|
SSB (w/ 100W slug) | 42W
|
---|
|
---|
Dosy TC4001
|
---|
Voltage | 14VDC
|
---|
SWR | 1.2 with dummy load - 1.5 with Antron A99 Antenna
|
---|
Impedance | 50 ohm
|
---|
AM Carrier (low @ 20W scale) | 2-3W
|
---|
AM Carrier (high @ 20W scale) | 9-12W
|
---|
AM Modulation (PeP @ 200W scale) | 30W
|
---|
SSB | 30-35W
|
---|
|
---|
Height | 52mm (2in)
|
---|
Width | 170mm (6.7in)
|
---|
Length | 250mm (9.8in)
|
---|
Current | 10A
|
---|
*NOTE* The manual suggests using a 6A fuse, however the stock power cord uses a 15A fuse. This radio can draw slightly over 5A when modulating, we suggest ignoring the mis-print in the manual and using the actual fuse included with the radio. At least 10A, no more than 15A. |
---|
Package Bundle LINCOLN-DIGI Reviews
Contact Us
📍
- Walcott Radio
- 2940 N Plainview Rd Walcott
- Walcott, IA 52773
📞
- Phone Support
- 1-844-925-2688
- M-F 10am to 5pm CST
🕘
- Store Hours
- M-F 9am-6pm
- Sat 9am-5pm
- Sun Closed
Copyright 2024 Walcott Radio
Visit our Store! 2940 N Plainview Rd Walcott, Iowa 52773 USA