Super high performance and all the parts you need. Includes two Stryker SR-A10 10,000 watt super high performance CB antennas, heavy duty mounts built extra tough, and the Walcott 75 ohm high quality coax cable. If you've got the radio, and you need the rest, this is it. Works with standard mirror mount antenna systems.
UPDATE Stryker is now included 2 10" shafts, making the total length below the coil 20". This can cause high SWR issues unless you make some changes. If you're in a Kenworth T6XX truck, or a Freightliner Cascadia you will need to use the 20" total length. However, this will require you to cut a lot of the whip down to get your SWR set. If you use both shafts, you may need to cut over 4-8" of the whip off to get your SWR set. Alternatively, if you remove one of the shafts and reduce the overall length to 10" below the coil, you may have to remove much less, or none of the whip to get your SWR set.
SRA10PAIR-B2 Technical Specifications
6 Gauge Solid Copper 100% Silver Plate Wire
10,000 Watts Power Handling Capability
Extremely Efficient High Coil
Double Wall Coil Cover made from High Impact Mobay Plastic
Can be Tune for 26 - 30 Mhz
10 in Stainless Steel Shaft
49 in Stainless Steel Whip
Reduced Static Interference
Standard 3/8 in Thread on Shaft
2 Year Warranty
How do I tune Stryker SRA10 Antennas?
Check your SWR on channels 1, 20 and 40. If channel 40 is higher than one, remove the whip from the antenna, cut 1" off, then re-install and re-check your readings. Keep doing this until channels 1 and 40 have the same reading. For more detailed steps, check our guide here SWR Tuning Guide
