- Description
- Technical Details
- Warranty
SR655HPC Features
- High PowerThe SR-655HPC is uses four FQP13N10 MOSFET transistors that produce 70+ watts PEP. If you want be heard, the SR-655HPC has the power required to do some serious talking.
- Digital Echo with/ Dual Front Mounted ControlsProvides the Stryker CB radio operator a much wider range of effects and control than typical factory or aftermarket echo boards. Our board is able to reproduce the human voice with virtually no distortion providing maximum clarity and enjoyment.
- 7-Color Frequency DisplayThe SR-655HPC features a 7-Color frequency display (Stryker Exclusive)
- Brilliant 7-Color LED Backlit Face PlateChoose from 7 colors with the push of a button or let the CPU controller scan through all of the colors on it's own. Our exclusive face plate design provides operators with back lighted controls, making adjustments even in the darkest conditions easy.
- Dimmer ControlWe listened to your feedback over the years and that's why the SR-655HPC comes with a 32 position dimmer circuit with the lowest position turning the lights all the way off. If your eyes are sensitive to certain lights in the dark this is a must have feature!
- ClarifierOur clarifier gives you the option of choosing if you want the fine control to be used only on receive or also on transmit. You can also select how much range the fine and coarse clarifiers have.
- Band / VFOYou can choose between using traditional band mode or VFO mode on your Stryker CB radio for continuous operation throughout the frequency range.
- PC ProgrammableYou can further customize your Stryker CB radio using your PC! USB Smart Cable Sold separately
- Six Roger BeepsSix different roger beeps are included with the SR-655HPC. These are controlled using a switched that is located on the front panel of the Stryker CB radio. This is a feature that you will find on virtually no other radio direct from the factory. Most importantly you can create your own customizable roger beeps using our PC software and then load them on to the SR-655PHC's on board memory!.
- Variable Power ControlAllows the operator to adjust or vary their carrier from a two watt to over 70 watts PEP.
- Variable Talk Back ControlThe infamous talk back squeal is virtually eliminated with our independently controlled talk back circuitry. The Stryker CB radio operator can adjust the volume to the perfect level as operating conditions require. Best of all the user no longer has to turn down the microphone gain to stop the annoying squeal that is often the result of poor design or cost cutting at the production level.
- Up-Armored ReceiverOur exclusive receiver protection works even under the harshest conditions, such as those experienced at a busy truck stop with many operators running high power radios. In addition our receiver filtering is tighter than most radios on the market. This means adjacent channel rejection is improved!
Important notes on power output | |
|---|---|
Measuring power output will vary depending on many variables. Our default test-setup consists of a 14-volt power supply, 50 ohm dummy load, and Bird wattmeter reading PeP (peak envelope power). If you are using different equipment, measuring RMS instead of PeP, or have an SWR reading different than shown, you may have different results. The following chart shows an example of power readings for this radio with changes to measurement variables. Final note, the Dosy meter referenced below is directly affected by the SWR readings in the antenna system. You may notice huge differences in power readings from subtle changes in SWR. | |
Bird Wattmeter | |
| Voltage | 14VDC |
| SWR | 1.2 with dummy load |
| Impedance | 50 ohm |
| AM Carrier (low w/ 50W slug) | 2W |
| AM Carrier (high w/ 50W slug) | 15W |
| AM Modulation (PeP w/ 100W slug) | 80-85W |
Dosy TC4001 | |
| Voltage | 14VDC |
| SWR | 1.2 with dummy load |
| Impedance | 50 ohm |
| AM Carrier (low @ 20W scale) | 0.75W |
| AM Carrier (high @ 20W scale) | 15W |
| AM Modulation (PeP @ 200W scale) | 60W |
Dosy TC4001 | |
| Voltage | 14VDC |
| SWR | 1.5 with Antron A99 |
| Impedance | 50 ohm |
| AM Carrier (low @ 20W scale) | 1W |
| AM Carrier (high @ 20W scale) | 25W |
| AM Modulation (PeP @ 200W scale) | 70W |
| NOTE | Changing SWR from 1.2 to 1.5 causes the Dosy meter power readings to drastically change |
Standard Specifications | |
| Modes | AM / FM |
| Frequency Range | 10 Meter 28~29 MHz |
| Length | 11 1/8" from heatsink to bezel |
| Length | 12 1/8" from heatsink to control knobs |
| Width | 8" |
| Height | 2 3/8" |
| Current Draw | 15 Amp |
| Fuse Size | 20 Amp |
| Microphone Pin-Out | Standard 4-Pin |
| Power Connection | Standard 3-Pin |
In-house warranty for 90 days from date of purchase, manufacturer warranty from 3 years of purchase.
Stryker SR655HPC Reviews
Mike K.
5 months ago
You NEED this radio
This thing is a monster!
One quick, painless phone call was all it took for Glenn to get me set up with exactly what I was after!
One quick, painless phone call was all it took for Glenn to get me set up with exactly what I was after!
Darryl L.
Verified Buyer
9 years ago
great power without distortion. receive thats outstandingnone but will keep this updatedI love this radio. I get nothing but compliments from other drivers. It has the power to be heard without any distortion and the receive it great. Thank you Walcott the set up was perfect and thank you for the recommendation for the 655hp. This is the best radio I have ever owned.
Tom C.
10 years ago
Really good features and great soundHowever if you want more power consider the Stryker SR497HPCGood radio and great sound on TX. I strongly recommend a noise canceling mic.
Contact Us
📍
- Walcott Radio
- 2940 N Plainview Rd Walcott
- Walcott, IA 52773
📞
- Phone Support
- 1-844-925-2688
- M-F 10am to 5pm CST
🕘
- Store Hours
- M-F 9am-6pm
- Sat 9am-5pm
- Sun Closed
Shop
My Account
Customer Service
Company Information
Copyright 2024 Walcott Radio
Visit our Store! 2940 N Plainview Rd Walcott, Iowa 52773 USA