Double Your Radio Fun with this Tough Talker Dual Band HT!
Engineered for success, this dual-bander is packed with features:
2m/70cm dual-band hand held transceiver
Choice of 3 power output levels: High 5W(13.8VDC), Low 0.5W and user-selectable Mid-power (1-3W)
Quick-write memory channel (Uses a single key touch to copy current VFO data to the Lowest number of memory channels available)
Direct frequency input through illuminated keypad
High-grade water-resistant materials compatible to IPX7
Rugged polycarbonate body resists dirt and dust
Great audio with large 40mm internal speaker
Easy-to-read backlit alphanumeric display
200 Memories, plus one call channel on each band
VFO, Memory and Scan modes
39 CTCSS tone squelch (encode + decode) and 104 DCS
Search-scan (programmed scanning) available on each band
Tone burst function (1000, 1450, 1750 and 2100Hz)
Battery-drain function avoids memory effect
Two-touch repeater-setting access
Wire cloning capability
SMA antenna port
DTMF encode and auto-dialer
[T: TX] 144 - 147.995MHz, 420 - 449.995MHz
[T: RX] 136 - 173.995MHz, 400 - 511.995MHz
[E: TX/RX] 144 - 145.995MHz, 420 - 439.995MHz
5,10, 12.5, 15, 20, 25, 30kHz step
200 memory channels in total + 1 call channel/band + 1 Repeater-Access parameter memory/band
DC 7.0 - 16.0V (EXT DC-IN)
TX at High power VHF 1.6A, UHF 1.9 @ 13.8V
RX at 500mW AF out: 250mA
Battery-save ON: average 27mA
Unit -10digC to 60digC (+14digF to +140digF) Battery packs: -10digC to +45digC (+14digF to +113digF)
58(W)x110(H)x36.4(D)mm (2.28"(W)x4.33"(H)x1.43"(D)) with EBP-63 w/o projection
Approx.270g (9.6oz) with EBP-63 & antenna
DC13.8V: 5W / 2W / 0.5W
Battery packs (7.2 - 7.5Vdc): VHF5W - UHF 4.5W / 2W / 0.5W
Variable reactance FM
-60dB or less
FM : +/- 5KHz NFM: +/- 2.5KHz
Double-conversion super heterodyne
-14.0dBu (0.2uV) or less
1st IF 38.85MHz 2nd IF 450kHz
-6dB: 12kHz or more -60dB: 35kHz or less
More than 400mW (8ohm, 10% distortion) / Max 500mW
Specifications subject to change without notice or obligation. Specifications apply to Amateur Radio bands only. Permits required for MARS use. Product intended for use by properly licensed operators.
T-version : AC adapter EDC-146 / Belt clip / EBC-22 / Rubber duck antenna EA-114 / Carry strap / Ni-MH Battery pack EBP-65 (7.2V 700mAh)
E-version : Battery Charger EDC-159E / Belt clip EBC-22 / Rubber duck / antenna EA-114 / Carry strap / Li-ion Battery pack EBP-63 (7.4V 1100mAh)
Thank you , Jason, You can expect more business from us in the future. George-- George D.
Just wanted to thank you for your service on this order. I received the replacement slip seat box and speaker, and also the correct size slip seat box cover earlier this week, in two shipments. The cover was the correct size this time (I sent the smaller one back with the supplied ground label), but more importantly, the replacement slip seat box and speaker were received in beautiful condition; while the first slip seat box was shipped in just the manufacturer's box, with no additional shipping box or material, and the speaker rattling around inside it, the second shipment was packed with bubble material in addition to an exterior shipping carton. Had the original shipment been packed in the same manner the replacement was, I'm sure there would have been no damage whatsoever. UPS came on 4/27 and picked up the original carton with the damaged slip seat box and speaker enclosed. Again, thank you for taking a personal interest in this oder and for resolving it so efficiently. I hope to do business with Walcott again, and will make an effort to stop in when I next get out to the Iowa 80 area. Sincerely, Doug Lyons-- Doug L.
HELLO JASON, I RECECEIVED THE ANTENNA I ORDERED FROM YOU GUYS AND IT LOOKS GREAT. I HAVE YET TO TRY IT OUT, BUT IT LOOKS LIKE ITS GOING TO BE FINE. UPS HAD NO PROBLEM FINDING ME SO I'M LOOKING FORWARD TO DOING MORE BUSINESS WITH YOU. JUST THOUGHT I'D LET YOU KNOW IT WORKED OUT. THANKS AGAIN ROBERT-- Robert F.
Just wanted to write you guys a note telling you thanks for the help you gave me over the phone. I got my stuff today and it was an easy installation. I own a 99 Yamaha Venture and needed a cb antenna. I called you guys and you were very helpful and understanding of what I needed. I just wanted to tell you that it was a pleasure working with you. I'm on a couple of Venture forums and I will be endorsing you guys and recomending you guys. If you are interested here is the link: http://forums.delphiforums.com/vrider/start Thanks again. If I need some more electronic stuff, I'll be calling you guys again. Later, Tony-- Tony H.